This study has the objective to better constrain the role played by thermal erosion by turbulent lava in the formation of large channels on Mars and the Moon. On Mars, a rigorous one-dimensional model was used to test whether lava might have excavated the Athabasca Valles outflow channel. Calculated erosion depths are much lower than the measured depths of the channel, and suggest a limited role played by thermal erosion in excavating it. On the Moon, the investigation focused on the outer and inner sinuous rilles of Vallis Schröteri. At this site, erosional features cannot be explained by one- and two-dimensional models. The first 3-D model of thermal erosion by turbulent lava on the Moon was created to relate the spatial distribution of erosion rates over the bed and banks of a channel with changes in fluid- and thermodynamic parameters. The turbulence model chosen for each steady-state simulation is the Shear Stress Transport (SST) k-ω model and OpenFOAM is the Computational Fluid Dynamics software used. At the 150-km-long, 4-km-wide, and up-to 700-m-deep outer rille, I aimed to determine maximum erosion rates at/near the lava source and rille segments 1-km-long and 4-km-wide were chosen for the simulations. By adopting the obtained maximum erosion rates of 1 m/day, lava might have taken ~2 years to excavate the 700-m-deep depression. These fast erosion rates were unlikely maintained downstream of the lava source unless lava flowed in a tube. Besides, observational evidence suggests that tectonics and constructional processes likely contributed to rille development. On these grounds, thermal or thermo-mechanical erosion might have contributed to rille formation at a later stage. At the Vallis Schröteri inner rille, 1-km-long and 160-m-wide meandering channels were chosen. In one scenario, lava loses heat by radiation, in the other flows in a tube. Using the calculated (and conservative) erosion rate of 50 cm/day, it would have taken ~6 months for the 90-m deep inner rille to be excavated. A mechanism of secondary flow circulation analogous to that found in meandering rivers potentially explains meander generation. At each bend, downstream and cross-stream velocity variations lead to local temperature/ erosion enhancements.

Planetary mineralogy provides important clues about a planet’s geologic history, specifically how the planet first solidified and what geological processes have taken place since. I used spectral and composition data from the Mars Science Laboratory Curiosity rover to study some of the most recent geologic events on Mars. I also used modeled mineralogy of hypothetical exoplanets to understand the initial crystallization of exoplanets. Orbital data of Mt. Sharp, a ~5 km tall mound of sedimentary material, in Gale crater suggests that minerals associated with liquid water are present. These minerals, such as hydrated Mg-sulfates that are left behind as water evaporates, likely represent the beginning of Mars’ transition from a warm wet planet to the cold dry planet it is today.To understand how the mineralogy of Mt. Sharp changed, I used data from the Mastcam instrument on Curiosity to collect visible to near-infrared spectra of rocks from Vera Rubin Ridge and the Carolyn Shoemaker formation. Additionally, I collected laboratory spectra of powered binary mineral mixtures to understand how common minerals such as plagioclase, pyroxene, and hematite might obscure the spectral features of phyllosilicates and Mg-sulfates. Lastly, to better understanding Mars’ mineralogy, I analyzed numerous mixtures with Mg-sulfates in a nitrogen filled glovebox to better represent some of the environmental conditions of present-day Mars. Minerals such as phyllosilicates and Mg-sulfates, often referred to as secondary minerals, are only found on planets that have experienced alteration since the planet first solidified. The current level of understanding of Martian mineralogy has only been obtained after decades of sending numerous orbital and landed missions with intricate science instruments. But there is not this level of understanding for all planets, and especially not for planets outside of the solar system. Using modeled mineralogy, I deciphered the order in which primary minerals (i.e., olivine, pyroxenes, and plagioclase) could have formed as exoplanets first solidified. Understanding the mineralogy of planetary bodies gives insight into the geologic history of processes that cannot be seen, because they are no longer occurring, or even of planets that are difficult to find.