Development and Integration of Readout Systems for the Simons Observatory and Measuring the Extragalactic Background Light from Optical Stacking of Quiescent Galaxies at Cosmic Noon

Building on the legacies of Planck and the Atacama Cosmology Telescope, among others, future cosmic microwave background (CMB) observatories are poised to revolutionize our understanding of the cosmos by implementing proven detector systems at scales previously incomprehensible. Leading the charge is Simons Observatory (SO), a suite of four telescopes located at 5,200 meters elevation in the Atacama Desert of Chile. With more than 60,000 transition-edge sensor (TES) detectors deployed in six frequency bands across three half-meter telescopes and one 6-meter telescope, SO will observe CMB temperature and polarization at small and large scales with greater sensitivity and control over systematics than has yet been achieved. In deploying more detectors than all other previous CMB experiments combined, SO must also chart new territory in the realm of TES readout. Breakthroughs in microwave multiplexing (μ-mux) readout technology now allow the simultaneous readout of approximately 1,000 detectors on a single set of cables, far surpassing the capabilities of previous systems. For the Large Aperture Telescope’s >30,000 detectors, this translates to a total of just 45 input/output lines. A crucial piece of the SO readout architecture is the Universal Readout Harness (URH), a "plug-and-play" assembly that contains the 300K-4K elements. Configurable to support the readout requirements of each receiver, each URH can support up to 24 readout lines. In addition to the radiofrequency (RF) components, the URH can also support up to 12x50-wire DC cable looms, which provide detector and amplifier power. This dissertation describes the construction and testing of the 6 URHs required for nominal SO operations, as well as the on-site integration of the first Small Aperture Telescope. Separately, an optical stacking analysis of quiescent galaxies at z~1 using images from the Dark Energy Survey is presented. Motivated by a desire to better understand the evolution of massive elliptical galaxies, high signal-to-noise images generated from averaging ~100,000 individual galaxy cutouts are used to calculate surface brightness profiles in the grizY bands. Additionally, the extragalactic background light is derived from these stacks and is found to be in good agreement with previous measurements.