Removal of Perfluoroalkyl Acids and Common Drinking Water Contaminants by Weak-Base Anion Exchange Resins

Although anion exchange resins (AERs) have been implemented for a wide range of aqueous contaminants including notorious perfluoroalkyl acids (PFAAs) that are of human health concern, the potential benefits and underlying chemistry of weak-base (WB) AERs are overlooked. To fill these key gaps in the literature, this research evaluated the removal and regeneration efficiency of WB-AER (IRA 67 and IRA 96) with strong-base (SB) AER as the baseline. Batch equilibrium tests were first conducted for the removal of nitrate, sulfate, 3-phenylpropionic acid, and six legacy PFAAs with contrasting properties at different solution pH using polyacrylic and polystyrene chloride-form AERs. In ambient (pH 7) and acidic (pH 4) solutions, the polymer composition was the controlling factor followed by the length of alkyl chain of the resin while AER basicity did not influence the selectivity for the selected contaminants. WB resin had higher capacity than SB analogs based on quantitative analysis using isotherm model parameters. Batch and column adsorption experiments showed significantly greater removal of PFAAs by polystyrene than polyacrylic AERs regardless of resin basicity, with the order of decreasing polyacrylic resin selectivity of PFOS >> PFHxS ≈ PFOA > PFBS > PFHxA ≈ PFBA. The removal performance of WB-AER was reversible, declining drastically at basic conditions and gradually regained once below the pKa of the resin due to the pH-dependent nature of amine groups. This was not the case for IRA 96 (i.e., polystyrene) which exhibited high removal of PFAAs irrelevant of pH because of the nonpolar character of polystyrene matrix. The non-hydrophobic IRA 67 (i.e., polyacrylic) had a satisfactory regeneration using non-toxic salt-only solutions comprising 1% NaOH and 0.5% NaOH + 0.5% NaCl, while IRA 96 was only amenable to brine/methanol regeneration. Important caveats on the validity of isotherm modeling in batch adsorption tests were discussed. Results for batch and column experiments using chloride-form and free-base form WB-AER, respectively, provide insights for industrial applications.