Extending the Jumping Range of a Small Robot via Collapsible Gliding Wings

This project is investigating the impact curvature, buckling, and anisotropy play when used passively to enhance jumping capability. In this paper we employ a curved structure to allow a rigid link to collapse preferentially in one direction when it encounters aerodynamic drag forces. A joint of this nature could be used for passively actuated jump gliding, where wings would collapse immediately on takeoff and passively redeploy during descent, allowing the jumping robot to extend its horizontal range via gliding. A passively actuated joint is simpler and more lightweight than active solutions, allowing for a lighter glider and higher jumps. To test this, several prototype collapsing gliding wings of different diameters were tested by dropping them from a consistent height above the ground and by launching them upwards and recording their initial velocity. A model was constructed in Python using the data gathered through the experiments and was tuned so that its outputs were as close as possible to the experimental results. As expected, increasing the wing diameter increased the total fall time, and increasing the payload mass decreased the total fall time. Orientation of the wings around the vertical axis of the glider relative to the direction of horizontal motion was also found to have an effect on the length of time between when the gliding platform was launched and when it made contact with the ground, with a configuration where the axis between the wings was parallel to the direction of motion granting added stability.